Monitoring

STEP – 7

Monitor the Sensor Data on TPC Platform

If you have completed all steps correctly, you should be seeing the data sent by the end-device on the webhook site

At this step, you will have a look at the application that you created and observe the data traffic .. You can access to Application information via Applications > List on the menu as shown below.

Select Applications from the main menu

Select List from the sub menu to list of the Applications that which had been configured on TPE

List of all defined Applications listed

Green DOT means, Application is ONLINE

At this step, you will have a look at the application that you created and observe the data traffic .. You can access to Application information via Applications > List on the menu as shown below.

You can review the Definitions that you had been entered at Step 6 and you can change them

Application ID (automatically assigned) and Tunnel Interface Authentication Key (automatically assigned) fields can not be changed

When successfully connected to WiFi Network you selected, following screen will be shown and MiniHub- Gateway will reboot automatically. i.e you wont be able to access to Gateway via web browser again. Access to Gateway is only possible on AP Mode (i.e. Config Mode)

If connection to selected WiFi AP is successful, it displays GW’s ip address

LoRaWAN® GW reboots automatically and status will into GREEN

LoRaWAN® GW will not be shown at WiFi AP list anymore

In the Last 25 Packets Section, you can monitor the data packets that had been forwarded to backend application

Last 25 packages that forwarded to Backend Application

LoRaGW Register