If you have completed all steps correctly, you should be seeing the data sent by the end-device on the webhook site
STEP – 7
Monitor the Sensor Data on TPC Platform
At this step, you will have a look at the application that you created and observe the data traffic .. You can access to Application information via Applications > List on the menu as shown below.
![](https://community.thingpark.org/wp-content/uploads/2022/01/step-7.jpg)
At this step, you will have a look at the application that you created and observe the data traffic .. You can access to Application information via Applications > List on the menu as shown below.
![](https://community.thingpark.org/wp-content/uploads/2022/01/step-2-2.jpg)
When successfully connected to WiFi Network you selected, following screen will be shown and MiniHub- Gateway will reboot automatically. i.e you wont be able to access to Gateway via web browser again. Access to Gateway is only possible on AP Mode (i.e. Config Mode)
![](https://community.thingpark.org/wp-content/uploads/2022/01/step-7-2.jpg)
In the Last 25 Packets Section, you can monitor the data packets that had been forwarded to backend application
![](https://community.thingpark.org/wp-content/uploads/2022/01/step-7-3.jpg)